Search found 4 matches

by unebonnevie
Tue Nov 23, 2021 6:52 am
Forum: Other Hardware interfaces
Topic: How to program the ProStart LPC1114 with LPC's FlashMagic
Replies: 4
Views: 3876

Re: How to program the ProStart LPC1114 with LPC's FlashMagic

Woot! That did it! Connect the "Load C" pin to GND pin will get the LPC1114 programmed at 115200 baud via FlashMagic successfully!

THANK YOU @olzeke51!!!
by unebonnevie
Tue Nov 23, 2021 1:54 am
Forum: Other Hardware interfaces
Topic: How to program the ProStart LPC1114 with LPC's FlashMagic
Replies: 4
Views: 3876

Re: How to program the ProStart LPC1114 with LPC's FlashMagic

Thanks for the answer. Attached is the image. I drew the red line to the Load C hole/pin. You are talking about that pin, correct? That pin is traced to the Cn pin of the 6-pin header which I drew the other red line pointing to it. So, then I connect the Cn pin to GROUND then? And I do bare metal st...
by unebonnevie
Sun Nov 21, 2021 6:23 am
Forum: Other Hardware interfaces
Topic: How to program the ProStart LPC1114 with LPC's FlashMagic
Replies: 4
Views: 3876

How to program the ProStart LPC1114 with LPC's FlashMagic

Hi all, I hope I posted to the right forum, but I was given a ProStart LPC1114 (https://www.coridium.us/coridium/shop/boards/bd20-prostart), and I am having a hard time of programming a piece of firmware using LPC's FlashMagic tool. The ProStart LPC1114 does not come with a USB-serial chip. So, I ba...
by unebonnevie
Wed Oct 21, 2015 3:05 am
Forum: Your first forum
Topic: Just got a Coridium PROStart board and some questions
Replies: 1
Views: 16862

Just got a Coridium PROStart board and some questions

I just got one and can't find documentation on C6, R1, R2, & R3, that is, their values. The schematic on the Coridium site does not help and is very old. I assume C6 goes to the top open read-to-solder pad just below the 't' of the word "PROStart" on the board? And what is the area with the 10 solde...