I have never been able to brick a part since some early versions were fixed. You can always get the part back into mBed mode by disconnecting from USB, shorting pins 3 and 4 (there is a white box around those on the silk screen). Then plug it in and on Windows it will show up as a disk drive, usual...

I believe that my LPC is dead . It never connects. Now, it does not connect in windows 10 either, when yesterday it did. I believe that so many tests have done something to him, and it does not communicate. Windows detects it well, but neither the BASIC nor the C connect, they always say error in CO...

basicchip, In addition to the LPC11U37, I also have three teensy (3.0, 3.1 and 3.6) and the 3.1 I have with the coridium basic "teensy31.hex" (my personality file). Well, in the "old" version of BasicTools v5.55 where I started programming the teensy 3.1, it works fine, but in the new 6.02D, it tell...

Hello @jepalza, where did you get this version of BasicTools?? Hooray - that driver worked for me with Win-7 (32) Home Premium Service Pack 1 I am running BASICtools 6.02d I just downloaded this morning and only got [6.00] TIA - Olzeke That's not me, it's "robots42", but it does not matter. Version...

Can you tell me what sequence you go through to see that? At start, all time. Drivers are correct, Windows say "LPC USB VCom Port (COM13)", BasicTools , new 6.02 versión, say "stop button", then "toggle reset", and "ser-open2, but error "Com13 not available..." Error: cannot find channel named "" S...

I can't to look it now, but i'm using the lastest versión, donwloaded from you web. (date of EXE is 11-jan-18)

nik282000 wrote: ↑

Mon Jan 22, 2018 8:19 pm

....However from there on BASICtools are unable to talk to the device giving the error "Com3 Not Available."

Just like me., it's the mistake that I get from time to time

Same for me, exactly, same version and date. but in my system, sometimes, when you have to record the program, it gives port error and it disconnects, and I must restart windows. It can be my windows failure, because I have many different programming units, like TEENSY, ARDUINO, XILINX (by JTAG and ...

I found an NXP LPClink2 board, and it also uses a USB_SER connection. NXP published a driver update utility for this and I have loaded that to our site. I would only use this for Win7. https://coridium.us/files/lpc_driver_setup.exe Did probe it: Windows found my device with this drivers, and detect...

ok, the problem is windows 7, I have tested in windows 10, and has detected the first time, as VCOM. No problem, and it works well. But in windows 7 x64 SP1 "without updating" (important note), it does not work well, the COM port is disconnected many times. My win7 is not updated, because I use it e...