www.coridium.us/forum

Hello Basicchip - (the 'windoz' guy')
Gary here (a real Linux user).
.
Using TclTerm.tcl on Linux - it is simple to use, I enjoy it.
The Windows version will allow me to change the baud rate, BUT not the Linux version.
Some of my boards use a lower speed UART.
.
Could the pull down for Baud Rate be added??
Thanks for listening/considering.
Gary

Still don't have a Linux machine up, wsl on windows doesn't run wish (don't know how to configure Xwindows for it)

I ordered a power supply for my HP mini, which has Mint on it. Power supply misplaced in the move.

You might have to figure out the command line sequence to configure the baud rate for me.

Check out the blog post with an updated TclTerm.tcl

https://www.coridium.us/coridium/blog/a ... s-in-linux

Thank you,
I looked through the TT.tcl script but didn't see much about 'baud' in it.
Gary